Cooper Security i-on160EX Installation Guide download pdf (Page 136)

Step by Step Programming Procedures i-on160

Page 130

Outputs

Adding Radio Outputs

To teach the control unit's identity to a 762r, 768r or 769r:

1. Enter Installer Menu.

INSTALLER MENU

Detectors/Devices >

2. Press n until the display shows:

INSTALLER MENU

Outputs >

3. Press Y.

OUTPUTS

Radio Outputs >

4. Press Y .

RADIO OUTPUTS

Add Outputs >

5. Press Y.

The bottom line of the display shows the first of

the available radio expanders, for example:

ADD OUTPUTS

Exp. R1-02 (R30)>

6. Press u or n to select the expander that you

wish allocate the radio keypad to.

Note: This example assumes that your radio

expanders are bus devices 02 and 05. The

numbers may be different on the system you

are working on.

ADD OUTPUTS

Exp. R1-05 (R10)>

7. Press Y.

The top line of the display shows the first in a

list of unused radio outputs, for example:

ADD OUTPUT R1>05>01

Not Used >

8. Press u or n until the display shows the output

you wish to add, for example:

Note that if the bottom line of the display shows

an output name this indicates that the output

has been previously taught to a receiver.

ADD OUTPUT R1>05>03

Not Used >

9. Press Y.

Is receiver in learn

mode?

10. Make sure that the receiver is in learn mode

(see Appendix IV).

11. Press Y.

The control unit transmits its identity to the

receiver. When the receiver has successfully

learned the identity of the control unit it beeps

twice.

Did receiver beep

twice?

12. Press Y.

The display shows the menu option that allows

you to name the radio output.

EDIT O/P R1>05>03

Name >

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 179 180

Comments to this Manuals

No comments

Cooper Security i-on160EX Installation Guide Page 136

Comments to this Manuals

Related products and manuals for Security access control systems Cooper Security i-on160EX