Cooper Security Homelink 75 Installation Guide download pdf (Page 26)

Administration

Page 26

Message Volume

If you have voice prompts switched on (see page 18),

then you may wish to adjust their volume.

1. Enter the User Menu and select System Config –

Message Volume.

The display shows “Message Volume – Set Volume”

2. Press u to make voice prompts lounder, or n to

make them quieter. Every time you press one of

those keys the 7510r plays a beep to demonstrate

its new volume.

3. Press Done to accept the volume you have

selected.

Installer Access

You may wish to ensure that an installer or maintainer

cannot gain access to program your system unless a user

is present. To do this:

1. Enter the User Menu and select System Config –

Installer Access.

The display shows “User code to prog” with either

the letter Y or N at the end of the line.

2. Press CHANGE to change Y to N or N to Y.

A “Y” means that after the installer/maintainer

enters their access code, the system asks for a user

access code before allowing access to the Installer

Menu.

A “N” means that the installer/maintainer can enter

the Installer Menu by simply keying in their own

code.

3. Press Done to confirm your choice.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Cooper Security Homelink 75 Installation Guide Page 26