Cooper Security 9651 User's Guide download pdf (Page 20)

3. After an Alarm

Page 20 496930

To reinstate a zone repeat steps 1 to 4. At step 3 press Y and “o” will

disappear. Press X to exit.

Omissions are not permanent. When you unset the system the control unit

reinstates all omitted zones for the level you have unset.

Access Codes

The system can store up to 16 different user access codes. For security you

should give one code to each person who has responsibility for setting and

unsetting the system. Do not allow users to share codes.

Every time someone enters an access code on the keypad the system

records the event in its log. To distinguish all the users and keep their

access codes hidden, the log shows each user as a number, for example

"User 02", "User 03" and so on.

When delivered from the factory all access codes are set to default numbers.

User 01 default access code is "1234". You should change this immediately

to a code that only you know. User 01 is the only access code that can

change other access codes.

User 02 default access code is "X 002", User 03 is "X 003" and so on up to

User 16 (X 016). However, the default access codes for these users cannot

set or unset the system, or use any of its special functions.

Duress Code

If your system is connected to a communication device, you may want to

give some of the users a Duress Code as well as their normal access code.

If a user enters the Duress Code to unset the system, then the control unit

sends a silent Panic alarm call to the communication device. The Duress

Code is designed for times when a user is being forced to unset the alarm

system by an intruder.

The default Duress Code is "X017". This code is inactive until you change it.

5. Key in your access code (or present a tag) and press a Level key..

The control unit gives an error tone and the

display shows (for example):

Press Y.

If necessary, press Y again for each omitted zone shown on the

display.

(If you wish to escape press X.)

After you press Y for the final omitted zone the control unit starts to

set.

A:Omit Zone 07?

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Cooper Security 9651 User's Guide Page 20