Cooper Security 9651 User's Guide download pdf (Page 21)

3. After an Alarm

496930 Page 21

Changing Access Codes

1. Enter User 01 access code.

The display shows:

2. Press 4.

The display shows:

Note: If the system does not already have a code then it uses

002 for user 02,

003 for user 03 and so on.

Key in the access code you wish to change and

press Y.

The display shows (for example):

At this point you can change the text that the

system displays on the keypad for each user

code. See "Changing User Names" below. If you

do not wish to change the text then press Y again.

4. Key in the new access code that you wish to use.

Note: Do not use 0 (zero) as the first digit of the code.

If you wish to delete a code, key in "0000".

Press Y to store the new code.

Changing User Names

When you key in the access code and press Y in step 3 above, the display

shows the current user name with a flashing cursor under the first letter.

Enter letters from the keypad one at a time by pressing a number key

repeatedly until the display shows the letter you want. You may already be

familiar with typing out short messages on a mobile phone using the same

sort of system. Figure 3 on the next page shows which letters are assigned

to each key. Press C to move the cursor to the next space for a new letter.

If you make a mistake press C or D to move the cursor over the letter you

want to change, and key in the new letter. If you want to delete a name

completely press D to move the cursor under the extreme left hand character

of the name. Press D again. The display clears the old name.

The system can store a maximum of 12 characters per name, including

spaces and punctuation marks.

When you have finished entering the user name press Y.

Select?

Old Code=

U02:User 2

User 2 = ****

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Cooper Security 9651 User's Guide Page 21