i-on40 & i-onEX Range 3. Setting and Unsetting
Page 31
An expander or keypad
has a fault, or the
cabling between parts of
the system has a fault.
The AC supply has
stopped for more than
10 seconds.
The back-up battery has
a problem.
or
Part of the
communication system
has a problem.
The system has
detected a fault not
covered by the above
categories.
1
Your system may be programmed so that only the Installer
can override this fault.
Unsetting the System Using a Keypad
When unsetting the system do not stray from the entry route
designated by the installer. If you do so then you will cause an
alarm.
Start the Entry Procedure
1. Enter by the designated entry
door or route. (This usually
the last through which you
leave the premises.)
Go directly to the keypad.
The system starts the entry
timer. The keypad sounds the
entry tone (an interrupted
tone).
Comments to this Manuals