Cooper Security i-on160EX User Manual download pdf (Page 41)

i-on40 & i-onEX Range 3. Setting and Unsetting

Page 35

The keypad sounds the exit warning tone.

2. Complete setting using the method programmed by the

Installer (see “3. Finishing Setting” on page 26).

Unsetting

1. Enter by the designated entry door.

2. Press on your remote control.

The system unsets. At this point the system displays the standby

screen.

Note: Your administrator may have programmed the control unit

so that you cannot unset the alarm system using a remote

control. See page 105. However, if the entry timer has

started then you can still use your remote control to unset

the system.

If The System Will Not Set by Remote Control

If one of the detectors is still active when you try to set the

system then you will not hear the exit warning tone. Instead the

internal sounder will give a single beep.

What happens next depends on how the installer has set up your

system.

a) Try pressing A once more on your remote control. If the

installer has programmed the system to do so then it will

carry on and set, omitting the active detector.

b) If the system will not set on the second press of button A

then you will have to go to the keypad and set the system

from there.

Using a Two-Way Key Fob

Note:

1. You must ask your Administrator to provide a suitably

programmed Two-Way Key Fob, see page 95.

2. If your system is certified to BS8243 (ask your Installer)

then do not use a FOB-2W-4B as it will not comply with the

entry and exit requirements. (It could however be used on

a compliant system to unset the system if the building is

locked using electronic locks on the entry doors.)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 121 122

No comments

Cooper Security i-on160EX User Manual Page 41