Cooper Security 9651 Installation Manual download pdf (Page 61)

9651 Programming - Programming Commands

11772232 Page 57

87: Keypad Dual Key Alarms

This command enables users to raise an alarm by pressing two keys on the

keypad at the same time. Three types of alarms are available, each of which

can be enabled or disabled independently. The default is disabled (option 0).

Alarm type Key combination Disable Enable

PA 1 and 3 0 1

Medical 4 and 6 0 1

Fire 7 and 9 0 1

Press A and B to scroll up and down through the types (PA, FI and MD).

Note: Selecting option 1 also enables any PAs connected to 9928 keyswitch

interfaces or to 9940 keypads.

88: Anti Masking

Do not use.

90: Event Log

For information on this command, see page 68.

91 to 96: Testing Outputs

For information on these commands, see page 71.

97: Engineer Walk Test

For information on this command, see page 71.

98: Load Full Defaults

This command loads the original default values for all commands (for more

information, see page 32).

99: Leave Installer Mode

This command returns to user mode (for more information, see page 31).

106: Line Fault Response

This command sets how the control unit responds when it detects a fault on

an attached plug by communicator. The response depends on whether the

system is set or unset.

Option

0 Not used.

1 Audible (default).

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 87 88

No comments

Cooper Security 9651 Installation Manual Page 61