Cooper Security 9651 Installation Manual download pdf (Page 48)

Programming - Programming Commands 9651

Page 44 11772232

Note: The Alarm Abort period is controlled by the Alarm Receiving Centre

(ARC).

37: Daytime Tamper Communication

This command defines how the control unit reports tamper indications (for

example, an attempt to open a control unit or keypad case) while the alarm

system is unset.

Option

0 Internal sounder only (default).

1 Internal sounder and communication of tamper indication to the Alarm

Receiving Centre (ARC).

38: System Tamper User/Engineer Reset

This command defines how to reset the control unit after a tamper alarm (for

example, an attempt to open a control unit or keypad case).

To require an engineer reset, select option 1 (the default). To permit a user

reset provided that no fault exists, select option 0.

Note: This facility is independent of the options selected in Commands 31 and

33.

39: Level A Exit Mode

Use this command to select the exit mode for Full Set. The keypads give a

double "beep" confirmation tone at the end of all setting modes, including

Silent Set. The default is option 0, Timed.

Option

0 Timed. Use this option if the system sets after an exit time selected

using Command 44. If an Exit Terminate button is fitted, the user may

use it to shorten the exit time.

1 Terminated. Use this option if the user completes setting the system

by pushing an Exit Terminate button connected to a keypad. The exit

time is infinite in this option. The system sets 7–12 seconds after the

completed action; the delay is set with Command 182 (see page 64).

2 Final Door Set. Use this option to complete setting of the system by

closing a door fitted with a Final Exit zone detector. The exit time is

infinite in this option. The system sets 7–12 seconds after the

completed action; the delay is set with Command 182 (see page 64).

3 Lock Set. To use this option, you must install a lock switch and

connect its contacts to the ET terminals of a keypad (refer to the 9x5x

Installation Guide). This facility is available on keypad software

version 1.4.2 onwards. See the notes below for more information.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 87 88

No comments

Cooper Security 9651 Installation Manual Page 48