Cooper Security 9651 Installation Manual download pdf (Page 71)

9651 Programming - Programming Commands

11772232 Page 67

Setting Entry Timers for both FE and ER Zones

Suppose that you have installed a system that uses the Final Door exit mode.

In this case, the entry timer will usually be started when a user opens the final

door. It might seem unnecessary to assign an entry timer to an ER zone set

up inside but there are two types of situations which make it useful to do so.

1. In a house where the keypad is near the final door (for example, in the

hall), the entry time for a user coming through the door and unsetting the

system might be short (for example, 20 seconds). However, if the stairs

from the bedrooms descend into the living room (rather than the hall) and

you set up a detector there as an ER zone, users coming downstairs in the

morning may need longer to reach the keypad and unset the system.

Assigning a longer timer to the ER zone allows for this requirement.

2. If a final door develops a fault and has to be omitted from the system, the

control unit treats ER zones as FE zones and so they need entry timers.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 87 88

No comments

Cooper Security 9651 Installation Manual Page 71