Cooper Security Homelink 75 User's Guide download pdf (Page 30)

Programming Reference - Outputs 7510r

Page 26

operates when the system is in alarm, and remains

active until the user disarms the system.

Note: For best results use this output type on a strobe

connected to a 770r Wireless Access Module. The

strobe on a 750r cannot respond correctly because of

the battery saving circuits within the radio siren.

Pulse Set

This output becomes active for a minimum of 1

second when any partition is fully set.

Pulse Unset

This output becomes active for 1 second when

someone unsets the system, or during a fire or PA

alarm.

Setting Complete

This output becomes active for 10 seconds when the

control unit finishes setting.

Siren P1 (to P4)

The control unit operates this output when the

selected partition is in alarm. See page 42 to choose

the siren delay and duration.

Strobe Set P1 (to P4)

This output is active for 10 seconds after the selected

partition has set. The output also operates when the

partition is in alarm and remains active until the user

disarms the partition.

Note: For best results use this output type on a

strobe connected to a 770r Wireless Access Module.

The strobe on a 750r cannot respond correctly

because of the battery saving circuits within the radio

siren.

Technical Alarm

This output becomes active during a technical alarm.

Medical

This output becomes active during a medical alarm.

This output becomes active during a panic alarm.

Fire

This output becomes active during a fire alarm.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 83 84

No comments

Cooper Security Homelink 75 User's Guide Page 30