Cooper Security Homelink 75 User's Guide download pdf (Page 45)

7510r Programming Reference - System Options

Page 41

Note that Factory Defaults sets all reporting defaults to

UK values, changes the language to English, and erases

all names and stored texts. However, select Factory

Defaults does not erase the log or stored voice memos.

Installer Code

The default Installer access code is 7890. Cooper Security

Ltd recommend that you change this code to some other

number. To change the Installer access code select

System Options

Installer Code

The Installer code allows you to enter the Installer Menu,

and carry out an Installer reset. However, the Installer

code does not allow you to set or unset the system.

Tcmd needs Entry

If you wish the user to unset the alarm system before

entering the premises then you can program the control

unit to unset the system in response to a signal from a

telecommand. Select: System Options, Tcmd needs Entry.

The options available are:

Enabled: The user must first trigger an entry zone and

start the entry timer before unsetting the system.

Disabled: The user can unset the system using a

telecommand without first starting the entry timer.

PA Response

When a user operates a PA zone, the system can respond

in one of two ways:

Full

The system operates the siren and, if programmed to

do so, sends a PA message to the ARC. The display

shows the PA zone when a user disarms the system.

Silent

The siren stays silent. If programmed to do so the

system sends a PA message to the ARC. The display

shows the PA zone when a user disarms the system.

The change between Full or Silent select: System Options,

PA Response.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 83 84

No comments

Cooper Security Homelink 75 User's Guide Page 45