Cooper Security M2000 User's Guide download pdf (Page 54)

Engineer Menu 1-4 Engineering Manual

024 – First Knock

Activates when any double knock zone (page 28) activates for the first time; deactivates

when the zone is activated for the second time, when the system is reset or when the

double-knock timer has expired (page 63).

025 – Digi Failed

Activates when the built-in modem fails to communicate. This is otherwise known as

"Comms Fail".

026 – Digi Successful

Activates when the built-in modem communicates successfully.

027 – Digi Active

Activates when the built-in modem is activated; deactivates when the built-in modem has

finished communicating.

028 – 2nd Entry Only

Activates when any ward starts the 2nd Entry Dly timer (page 63); deactivates when the

second entry time expires.

029 – Entry Only

Activates when any ward starts its Entry Delay timer (page 61); deactivates when the ward

is unset or when the Entry Delay timer expires.

030 – Exit Only

Activates when any ward starts the exit procedure; deactivates when the ward is set.

031 – Exit / Entry

Activates when any ward is in entry or exit mode.

032 – Exit Fault

Activates when a zone is in a fault condition during the setting procedure (e.g. a zone that

does not have the Access attribute is activated); deactivates when the fault is no longer

present.

033 – Tamper Alarm

Activates when any type of tamper condition is triggered; deactivates when all tamper

conditions have been reset. This output acts as a "global" tamper indication for any type

of tamper.

034 – Rem Service Call

Activates when the system is online with a remote PC and the Downloader software.

035 – Code Accepted

Activates after any valid user code has been entered. The output deactivates one second

later if the output is latched, or for the length of the pulse if the output is pulsed.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 179 180

No comments

Cooper Security M2000 User's Guide Page 54