Cooper Security M2000 User's Guide download pdf (Page 62)

Engineer Menu 1-4 Engineering Manual

05 – Alarm

Activates when the selected ward has a full alarm (page 22); deactivates when the alarm

has been reset.

06 – P.A. Alarm

Activates when a PA Silent or PA Audible zone (page 23) triggers, or if a user code of type

Panic Code is used. The output activates only if the zone or user code belongs to the

selected ward. The output deactivates when all such alarms applicable to the ward have

been reset.

07 – Fire Alm.

Activates when any Fire zone (see page 23) that is in the selected ward triggers. The Unset

Fire attribute (page 37) determines whether the output activates only when the zone is set,

or when the zone is either set or unset. The output deactivates when all Fire alarms in

zones associated with the ward have been reset.

08 – Set

Activates when the selected ward is set; deactivates when the selected ward is unset.

09 – 2nd Entry

Activates when the selected ward's 2nd Entry Dly timer is running (page 63).

10 – 24Hr Alm.

Activates when a 24 Hour zone (page 22) in the selected ward goes into the alarm state if

the panel is unset; deactivates when the alarm is reset.

11 – Cnf Alarm

Activates when a confirmed alarm (page 89) is detected by a zone in the selected ward,

and remains active until reset.

12 – Zone Omit

Activates when any zone in the selected ward is omitted or shunted (e.g. by user option 1-

2 or 1-3); deactivates when all zones in the selected ward have the omits/shunts removed.

13 – Act. Omit

If a latching sensor (such as a door contact or break glass, but NOT a PIR) activates a zone

in the selected ward, and the zone remains active until the end of the confirmation time

(page 62), the control panel omits the active zone and triggers the Active Omit output.

The control panel deactivates the output when a user resets the system.

14 – 24Hr Omit

Activates when the selected ward has one or more 24 Hour zones omitted; deactivates

when the selected ward has all its 24 Hour zones reinstated.

15 – Set Fail

Activates when the selected ward fails to set (e.g. because a zone is active); deactivates

when the selected ward is reset.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 179 180

No comments

Cooper Security M2000 User's Guide Page 62