Cooper Security M2000 User's Guide download pdf (Page 69)

Engineering Manual Engineer Menu 1-5

2 – Entry Delay

When the ward is set and the entry procedure is initiated, either by activation of the Final

Exit zone (page 23) or by activation of a Normal Alm zone that has the Entry attribute

(page 29) set to Yes, the Entry Delay timer starts to count down. The timer should allow

the user sufficient time to enter a valid user code after entering the building. If a valid user

code has not been entered when the timer reaches zero, an internal alarm (page 22) is

generated and the 2nd Entry Dly timer (page 63) is started. If the 2nd Entry Dly timer

reaches zero, a full alarm is generated, unless overridden by option 1-8-4 (page 83).

3 – Bell Delay

When a full alarm is triggered for the selected ward, activation of the external bell and

strobe outputs can be delayed by the value of this timer. This timer or Sys Bell Dly (page

62) is used, depending on the setting of the Ward Bell Time/Global Bell Time configuration

option (page 86).

)

The Bell & Strobe ward attribute (page 37) determines which wards trigger the bell

and strobe outputs.

)

Bell Delay or Sys Bell Dly are considered to be zero if Bells on Unconf (page 90) is

selected.

4 – Bell Duration

When the Bell Delay for the selected ward has expired, the duration of the external bell

output can be controlled by the value of this timer. This timer or Sys Bell Dur (page 63) is

used, depending on the setting of the Ward Bell Time/Global Bell Time configuration

option (page 86).

)

If Confirmation On and Bells on Unconf are selected (page 89), the bell and strobe

outputs switch off and the system re-arms if a second zone does not trigger within

the Confirmation time (page 62). If a second zone does trigger, causing a

confirmed alarm, the bell output (but not the strobe) is switched off when the Bell

Duration or Sys Bell Dur timer has expired. Bell Duration and Sys Bell Duration are

started after any programmed bell delays.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 179 180

No comments

Cooper Security M2000 User's Guide Page 69