Cooper Security M2000 User's Guide download pdf (Page 65)

Engineering Manual Engineer Menu 1-4

36 – PSU Fuse

Activates while a PSU Fuse zone (page 26) in the selected ward is active.

37 – PSU Mains

Activates while a PSU Power zone (page 26) in the selected ward is active.

38 – Mask Tamp

This is applicable only if the Mask Unset Tamp or Mask Set Tamper option is selected

(page 93). The output activates when a masking condition has been detected in the

selected ward (see page 26). The Anti Mask timer (page 63) delays activation of the

output.

39 – Mask Flt

This is applicable only if the Mask Unset Fault or Mask Set Fault option is selected (page

93). The output activates when a masking condition has been detected in the selected

ward (see page 26). The Anti Mask timer (page 63) delays activation of the output.

40 – Mask Alarm

The control unit operates this output when a suitably equipped detector reports masking

in its associated ward.

41 – Security

Activates when the selected Secure ward (page 37) is unset; deactivates when the Secure

ward is set.

42 – Supervision Fail

This output operates when there is a supervision failure on any radio zone allocated to the

ward programmed for this output. The output remains on until all supervision failures for

the ward are reset (see also option 1-9-3 17).

Note that to give a reliable indication of the location of the fault, you must assign each

MRNode to the appropriate ward (option 1-3-1), and each radio zone to the

appropriate ward (option 1-1).

43 – RF Jammed

The control unit operates this output when any MRNode reports jamming. The output

remains on until all jammed MRNodes report no jamming.

44 – Transmitter Low Battery

The control unit operates this output when any MRNode reports a wirefree detector with

low battery. (There is a separate output type for Telecommands and PAs.) The output

remains on until all MRNodes stop reporting detectors with low batteries.

45 – Telecommand Battery Low

The control unit operates this output when any MRNode reports a telecommand or PA

with low battery. The output remains on until all MRNodes stop reporting telecommands

or PAs with low batteries.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 179 180

No comments

Cooper Security M2000 User's Guide Page 65